产品概述 / Product Description
FTCS-1512-40Dxx 是北亿纤通(F-tone Networks)推出的 1.25Gb/s 1550nm 单模 SFP 光收发模块,采用 DFB 激光器与 PIN 光电探测器,在 9/125µm 单模光纤上最远传输 40km。
F-tone Networks’ FTCS-1512-40Dxx Small Form Factor Pluggable (SFP) transceivers are compatible with the Small Form Factor Pluggable Multi-Sourcing Agreement (MSA). The transceiver consists of five sections: the LD driver, the limiting amplifier, the digital diagnostic monitor, the DFB laser and the PIN photo-detector. The module data link up to 40km in 9/125um single mode fiber.
The optical output can be disabled by a TTL logic high-level input of Tx Disable, and the system also can disable the module via I2C. Tx Fault is provided to indicate that degradation of the laser. Loss of signal (LOS) output is provided to indicate the loss of an input optical signal of receiver or the link status with partner. The system can also get the LOS (or Link)/Disable/Fault information via I2C register access.

产品特点 / Product Features
- Up to 1.25Gb/s data links
- DFB laser transmitter and PIN photo-detector
- Up to 40km on 9/125µm SMF
- Hot-pluggable SFP footprint
- Duplex LC/UPC type pluggable optical interface
- Low power dissipation
- Metal enclosure, for lower EMI
- RoHS compliant and lead-free
- Single +3.3V power supply
- Support Digital Diagnostic Monitoring interface
- Compliant with SFF-8472
- Case operating temperature — Commercial: 0°C to +70°C;Extended: -10°C to +80°C;Industrial: -40°C to +85°C
应用场景 / Applications
- Switch to Switch Interface
- Gigabit Ethernet
- Switched Backplane Applications
- Router/Server Interface
- Other Optical Links
技术参数 / Specifications
绝对最大额定值 / Absolute Maximum Ratings
| Parameter | Symbol | Min. | Typ. | Max. | Unit | Note |
|---|---|---|---|---|---|---|
| Storage Temperature | Ts | -40 | 85 | ºC | ||
| Relative Humidity | RH | 5 | 95 | % | ||
| Power Supply Voltage | VCC | -0.5 | 4 | V | ||
| Signal Input Voltage | -0.3 | Vcc+0.3 | V | |||
| Receiver Damage Threshold | +5 | dBm |
推荐工作条件 / Recommended Operating Conditions
| Parameter | Symbol | Min. | Typ. | Max. | Unit | Note |
|---|---|---|---|---|---|---|
| Case Operating Temperature | Tcase | 0 | 70 | ºC | FTCS-1512-40D | |
| Case Operating Temperature | Tcase | -10 | 80 | ºC | FTCS-1512-40DE | |
| Case Operating Temperature | Tcase | -40 | 85 | ºC | FTCS-1512-40DI | |
| Power Supply Voltage | VCC | 3.13 | 3.3 | 3.47 | V | |
| Power Supply Current | ICC | 280 | mA | |||
| Power Supply Noise Rejection | 100 | mVp-p | 100Hz to 1MHz | |||
| Data Rate | 1250/1250 | Mbps | TX Rate/RX Rate | |||
| Transmission Distance | 40 | KM | ||||
| Coupled Fiber | Single mode fiber 9/125um SMF |
发射机规格 / Specification of Transmitter
| Parameter | Symbol | Min. | Typ. | Max. | Unit | Note |
|---|---|---|---|---|---|---|
| Average Output Power | POUT | -5 | 0 | dBm | Note (1) | |
| Extinction Ratio | ER | 9 | dB | |||
| Center Wavelength | λC | 1530 | 1550 | 1570 | nm | DFB Laser |
| Side Mode Suppression Ratio | SMSR | 30 | dB | |||
| Spectrum Bandwidth (RMS) | σ | 1 | nm | |||
| Transmitter OFF Output Power | POff | -45 | dBm | |||
| Differential Line Input Impedance | RIN | 90 | 100 | 110 | Ohm | |
| Output Eye Mask | Compliant with IEEE802.3 z (class 1 laser safety) | Note (2) |
Notes:
1. Measure at 2^7-1 NRZ PRBS pattern
接收机规格 / Specification of Receiver
| Parameter | Symbol | Min. | Typ. | Max. | Unit | Note |
|---|---|---|---|---|---|---|
| Input Optical Wavelength | λIN | 1270 | 1610 | nm | PIN-TIA | |
| Receiver Sensitivity | Sen | -24 | dBm | Note (1) | ||
| Input Saturation Power (Overload) | PSAT | -1 | dBm | |||
| Los Of Signal Assert | PA | -36 | dBm | |||
| Los Of Signal De-assert | PD | -25 | dBm | Note (2) | ||
| LOS Hysteresis | PA-PD | 0.5 | 2 | 6 | dB |
Notes:
1. Measured with Light source 1310nm, ER=9dB; BER =<10^-12 @PRBS=2^7-1 NRZ
2. When LOS de-asserted, the RX data+/- output is High-level (fixed)
电气接口特性 / Electrical Interface Characteristics
| Parameter | Symbol | Min. | Typ. | Max. | Unit | Note |
|---|---|---|---|---|---|---|
| Transmitter | ||||||
| Total Supply Current | ICC | A | mA | Note (1) | ||
| Transmitter Disable Input-High | VDISH | 2 | Vcc+0.3 | V | ||
| Transmitter Disable Input-Low | VDISL | 0 | 0.8 | V | ||
| Transmitter Fault Input-High | VDISL | 2 | Vcc+0.3 | V | ||
| Transmitter Fault Input-Low | VTxFH | 0 | 0.8 | V | ||
| Receiver | ||||||
| Total Supply Current | ICC | B | mA | Note (1) | ||
| LOSS Output Voltage-High | VLOSH | 2 | Vcc+0.3 | V | LVTTL | |
| LOSS Output Voltage-Low | VLOSL | 0 | 0.8 | V | ||
Notes:
1. A (TX) + B (RX) = 280mA (Not include termination circuit)
引脚定义 / Pin Descriptions

| Pin | Symbol | Name/Description | NOTE |
|---|---|---|---|
| 1 | VEET | Transmitter Ground (Common with Receiver Ground) | 1 |
| 2 | TFAULT | Transmitter Fault. | |
| 3 | TDIS | Transmitter Disable. Laser output disabled on high or open. | 2 |
| 4 | MOD_DEF (2) | Module Definition 2. Data line for Serial ID. | 3 |
| 5 | MOD_DEF (1) | Module Definition 1. Clock line for Serial ID. | 3 |
| 6 | MOD_DEF (0) | Module Definition 0. Grounded within the module. | 3 |
| 7 | Rate Select | No connection required | 4 |
| 8 | LOS | Loss of Signal indication. Logic 0 indicates normal operation. | 5 |
| 9 | VEER | Receiver Ground (Common with Transmitter Ground) | 1 |
| 10 | VEER | Receiver Ground (Common with Transmitter Ground) | 1 |
| 11 | VEER | Receiver Ground (Common with Transmitter Ground) | 1 |
| 12 | RD- | Receiver Inverted DATA out. AC Coupled | |
| 13 | RD+ | Receiver Non-inverted DATA out. AC Coupled | |
| 14 | VEER | Receiver Ground (Common with Transmitter Ground) | 1 |
| 15 | VCCR | Receiver Power Supply | |
| 16 | VCCT | Transmitter Power Supply | |
| 17 | VEET | Transmitter Ground (Common with Receiver Ground) | 1 |
| 18 | TD+ | Transmitter Non-Inverted DATA in. AC Coupled. | |
| 19 | TD- | Transmitter Inverted DATA in. AC Coupled. | |
| 20 | VEET | Transmitter Ground (Common with Receiver Ground) | 1 |
Notes:
1) Circuit ground is internally isolated from chassis ground.
2) Laser output disabled on TDIS >2.0V or open, enabled on TDIS <0.8V.
3) Should be pulled up with 4.7k – 10kohms on host board to a voltage between 2.0V and 3.6V. MOD_DEF (0) pulls line low to indicate module is plugged in.
4) This is an optional input used to control the receiver bandwidth for compatibility with multiple data rates (most likely Fiber Channel 1x and 2x Rates). If implemented, the input will be internally pulled down with >30kΩ resistor. The input states are: Low (0 – 0.8V): Reduced Bandwidth;(0.8 – 2.0V): Undefined;High (2.0 – 3.465V): Full Bandwidth;Open: Reduced Bandwidth.
5) LOS is open collector output should be pulled up with 4.7k – 10kohms on host board to a voltage between 2.0V and 3.6V. Logic 0 indicates normal operation; logic 1 indicates loss of signal.
数字诊断功能 / Digital Diagnostic Functions
F-tone Networks’ FTCS-1512-40Dxx transceivers support the 2-wire serial communication protocol as defined in the SFP MSA. It is very closely related to the E2PROM defined in the GBIC standard, with the same electrical specifications.
The standard SFP serial ID provides access to identification information that describes the transceiver’s capabilities, standard interfaces, manufacturer, and other information. Additionally, F-tone Networks’ SFP transceivers provide a unique enhanced digital diagnostic monitoring interface, which allows real-time access to device operating parameters such as transceiver temperature, laser bias current, transmitted optical power, received optical power and transceiver supply voltage. It also defines a sophisticated system of alarm and warning flags, which alerts end-users when particular operating parameters are outside of a factory set normal range.
The SFP MSA defines a 256-byte memory map in E2PROM that is accessible over a 2-wire serial interface at the 8 bit address 1010000X (A0h). The digital diagnostic monitoring interface makes use of the 8 bit address 1010001X (A2h), so the originally defined serial ID memory map remains unchanged. The interface is identical to, and is thus fully backward compatible with both the GBIC Specification and the SFP Multi Source Agreement.
The operating and diagnostics information is monitored and reported by a Digital Diagnostics Transceiver Controller (DDTC) inside the transceiver, which is accessed through a 2-wire serial interface. Digital diagnostics for the FTCS-1512-40Dxx are internally calibrated by default.
发射机眼图模板 / Transmitter Eye Mask Definition

机械尺寸 / Mechanical Specifications (Unit: mm)

符合性 / Regulatory Compliance
| Feature | Reference | Performance |
|---|---|---|
| Electrostatic discharge(ESD) | IEC/EN 61000-4-2 | Compatible with standards |
| Electromagnetic Interference (EMI) | FCC Part 15 Class B EN 55022 Class B (CISPR 22A) | Compatible with standards |
| Laser Eye Safety | FDA 21CFR 1040.10, 1040.11 IEC/EN 60825-1,2 | Class 1 laser product |
| Component Recognition | IEC/EN 60950,UL | Compatible with standards |
| ROHS | 2002/95/EC | Compatible with standards |
| EMC | EN61000-3 | Compatible with standards |
订购信息 / Ordering Information
| Product part Number | Data Rate (Mbps) | Media | Wavelength (nm) | Transmission Distance(km) | Temperature Range(Tcase)(℃) |
|---|---|---|---|---|---|
| FTCS-1512-40D | 1250 | Single mode fiber | 1550 | 40 | 0~70 (commercial) |
| FTCS-1512-40DE | 1250 | Single mode fiber | 1550 | 40 | -10~80 (extended) |
| FTCS-1512-40DI | 1250 | Single mode fiber | 1550 | 40 | -40~85 (industrial) |
| Part Number | Product Description |
|---|---|
| FTCS-1512-40D | SFP Transceiver, 1550nm, 1.25G, 40km, With DDM, 0℃~70℃ |
| FTCS-1512-40DI | SFP Transceiver, 1550nm, 1.25G, 40km, With DDM, -40℃~85℃ |
地区:中国四川天府新区
服务区域:全球
联系方式:
企业电话:028-85255257 | 企业传真:028-85977702 | 企业手机:19081343401
Site:https://www.f-tone.com
人事部:hr@f-tone.com | 市场部:sales@f-tone.com | 技术支持:support@f-tone.com
本产品为光模块产品线,详细信息,请联系我们的销售人员,谢谢!
Important Notice
Performance figures, data and any illustrative material provided in this data sheet are typical and must be specifically confirmed in writing by F-tone Networks before they become applicable to any particular order or contract. In accordance with the F-tone Networks policy of continuous improvement specifications may change without notice. The publication of information in this data sheet does not imply freedom from patent or other protective rights of F-tone Networks or others. Further details are available from any F-tone Networks sales representative.











