FTCS-Cxx03-80D 为 155Mbps 单模 CWDM SFP 光收发模块,传输距离可达 80 km。采用 CWDM DFB 激光器与 APD 光电探测器,波长由型号中的 Cxx 代码指定(27~61 对应 1270~1610nm,20nm 栅格),双工 LC 接口,单 +3.3V 供电,支持 SFP MSA 与 SFF-8472 实时数字诊断(DDM),提供商业级 0~+70℃ 与工业级 -40~+85℃ 温度规格,适用于 155M 光传输、快速以太网与 SONET OC-3 LR2 等场景。
产品特点 / Product Features
- 支持最高 155Mbps 速率
- 热插拔 SFP 封装
- CWDM DFB 激光器与 APD 光电探测器,单模传输最远 80km
- 符合 SFP MSA 与 SFF-8472,双工 LC 接口
- 符合 RoHS
- 单 +3.3V 供电
- 实时数字诊断监控(DDM)
- 工作温度:商业级 0~+70℃,工业级 -40~+85℃
应用场景 / Applications
- 155Mbps 光传输系统
- 快速以太网
- SONET OC-3 LR2
- 其他光链路
产品描述 / Description
该 SFP 光模块为高性能、低成本的 155Mbps 单模光收发一体模块,支持 80km 以内的单模光纤传输。
模块由三部分组成:CWDM DFB 激光发射单元、集成跨阻放大器(TIA)的 APD 光电探测接收单元,以及 MCU 控制单元。全部模块满足 Class 1 激光安全要求。
模块兼容 SFP 多源协议(MSA)与 SFF-8472 数字诊断功能。
极限条件 / Absolute Maximum Ratings
| 参数 Parameter | 符号 Symbol | 最小值 Min | 最大值 Max | 单位 Unit |
|---|---|---|---|---|
| Supply Voltage | Vcc | -0.5 | 4.5 | V |
| Storage Temperature | Ts | -40 | +85 | °C |
| Operating Humidity | – | 5 | 85 | % |
推荐工作条件 / Recommended Operating Conditions
| 参数 Parameter | 符号 Symbol | 最小值 Min | 典型值 Typ | 最大值 Max | 单位 Unit | |
|---|---|---|---|---|---|---|
| Operating Case Temperature | Tc | 0 | +70 | °C | ||
| Power Supply Voltage | Vcc | 3.135 | 3.30 | 3.465 | V | |
| Power Supply Current | Icc | 300 | mA | |||
| Data Rate | 155 | Mbps |
光学与电学特性 / Optical and Electrical Characteristics
发射端 / Transmitter
| 参数 Parameter | 符号 Symbol | 最小值 Min | 典型值 Typ | 最大值 Max | 单位 Unit | 备注 Notes |
|---|---|---|---|---|---|---|
| Centre Wavelength | λc | λc-6.5 | λc | λc+6.5 | nm | |
| Spectral Width(-20dB) | Δλ | 1 | nm | |||
| Side-Mode Suppression Ratio | SMSR | 30 | – | – | dB | |
| Average Output Power | Pout | 0 | +5 | dBm | 1 | |
| Extinction Ratio | ER | 9.0 | dB | |||
| Data Input Swing Differential | VIN | 180 | 1200 | mV | ||
| Input Differential Impedance | ZIN | 90 | 100 | 110 | Ω | |
| TX Disable | Disable | 2.0 | Vcc | V | ||
| TX Disable | Enable | 0 | 0.8 | V | ||
| TX Fault | Fault | 2.0 | Vcc | V | ||
| TX Fault | Normal | 0 | 0.8 | V |
接收端 / Receiver
| 参数 Parameter | 符号 Symbol | 最小值 Min | 典型值 Typ | 最大值 Max | 单位 Unit | 备注 Notes |
|---|---|---|---|---|---|---|
| Centre Wavelength | λc | 1260 | 1610 | nm | ||
| Receiver Sensitivity | -37 | dBm | 2 | |||
| Receiver Overload | -8 | dBm | ||||
| LOS De-Assert | LOSD | -38 | dBm | |||
| LOS Assert | LOSA | -45 | dBm | |||
| LOS Hysteresis | 0.5 | 4 | dB | |||
| Data Output Swing Differential | Vout | 600 | 800 | 1000 | mV | 3 |
| LOS | High | 2.0 | Vcc | V | ||
| LOS | Low | 0.8 | V |
时序与电学参数 / Timing and Electrical
| 参数 Parameter | 符号 Symbol | 最小值 Min | 典型值 Typ | 最大值 Max | 单位 Unit |
|---|---|---|---|---|---|
| Tx Disable Negate Time | t_on | 1 | ms | ||
| Tx Disable Assert Time | t_off | 10 | µs | ||
| Time To Initialize, including Reset of Tx Fault | t_init | 300 | ms | ||
| Tx Fault Assert Time | t_fault | 100 | µs | ||
| Tx Disable To Reset | t_reset | 10 | µs | ||
| LOS Assert Time | t_loss_on | 100 | µs | ||
| LOS De-assert Time | t_loss_off | 100 | µs | ||
| Serial ID Clock Rate | f_serial_clock | 100 | 400 | KHz | |
| MOD_DEF (0:2)-High | VH | 2 | Vcc | V | |
| MOD_DEF (0:2)-Low | VL | 0.8 | V |
数字诊断 / Diagnostics
| 参数 Parameter | 范围 Range | 单位 Unit | 精度 Accuracy | 校准 Calibration |
|---|---|---|---|---|
| Temperature | 0 to +70 | °C | ±3°C | Internal |
| Voltage | 3.0 to 3.6 | V | ±3% | Internal |
| Bias Current | 0 to 100 | mA | ±10% | Internal |
| TX Power | 0 to +5 | dBm | ±3dB | Internal |
| RX Power | -37 to -8 | dBm | ±3dB | Internal |
数字诊断存储映射 / Digital Diagnostic Memory Map
模块提供串行 ID 存储内容与当前工作状态的诊断信息,符合 SFF-8472 规范。
诊断信息可采用内部校准或外部校准方式实现,具体数据字段定义如下图所示。

图 1 数字诊断存储映射(A0h / A2h)
引脚定义 / Pin Descriptions

图 2 SFP 引脚定义示意图
| 引脚 Pin | 信号名称 Signal | 功能描述 Description | 插合顺序 Plug Seq. | 备注 Notes |
|---|---|---|---|---|
| 1 | VEET | Transmitter Ground | 1 | |
| 2 | TX FAULT | Transmitter Fault Indication | 3 | Note 1 |
| 3 | TX DISABLE | Transmitter Disable | 3 | Note 2 |
| 4 | SDA | SDA Serial Data Signal | 3 | |
| 5 | SCL | SCL Serial Clock Signal | 3 | |
| 6 | MOD_ABS | Module Absent. Grounded within the module | 3 | |
| 7 | RS0 | Not Connected | 3 | |
| 8 | LOS | Loss of Signal | 3 | Note 3 |
| 9 | VEER | Receiver ground | 1 | |
| 10 | VEER | Receiver ground | 1 | |
| 11 | VEER | Receiver ground | 1 | |
| 12 | RD- | Inv. Received Data Out | 3 | Note 4 |
| 13 | RD+ | Received Data Out | 3 | Note 4 |
| 14 | VEER | Receiver ground | 1 | |
| 15 | VCCR | Receiver Power Supply | 2 | |
| 16 | VCCT | Transmitter Power Supply | 2 | |
| 17 | VEET | Transmitter Ground | 1 | |
| 18 | TD+ | Transmit Data In | 3 | Note 5 |
| 19 | TD- | Inv. Transmit Data In | 3 | Note 5 |
| 20 | VEET | Transmitter Ground | 1 |
插合顺序(Plug Seq.):热插拔过程中引脚的接通次序。
1) TX Fault 为开集输出,主机板需以 4.7k~10kΩ 上拉至 2.0~Vcc 之间电压。
2) TDIS >2.0V 或悬空时激光输出关断,TDIS <0.8V 时开启。
3) LOS 为开集输出,主机板需以 4.7k~10kΩ 上拉至 2.0~Vcc 之间电压。
4) RD-/+:接收差分输出,内部 AC 耦合、100Ω 差分端接。
5) TD-/+:发射差分输入,内部 AC 耦合、100Ω 差分端接。
推荐接口电路 / Recommended Interface Circuit

图 3 推荐接口电路
机械尺寸 / Mechanical Dimensions

图 4 机械尺寸(单位:mm)
订购信息 / Ordering Information
| 型号 Part Number | 产品描述 Product Description |
|---|---|
| FTCS-Cxx03-80D | CWDM, 155Mbps, LC, 80km, 0°C~+70°C, with DDM |
地区:中国四川天府新区
服务区域:全球
联系方式:
企业电话:028-85255257 | 企业传真:028-85977702 | 企业手机:19081343401
Site:https://www.f-tone.com
人事部:hr@f-tone.com | 市场部:sales@f-tone.com | 技术支持:support@f-tone.com
本产品为CWDM SFP光模块产品线,详细信息,请联系我们的销售人员,谢谢!
Important Notice
Performance figures, data and any illustrative material provided in this data sheet are typical and must be specifically confirmed in writing by F-tone Networks before they become applicable to any particular order or contract. In accordance with the F-tone Networks policy of continuous improvement specifications may change without notice. The publication of information in this data sheet does not imply freedom from patent or other protective rights of F-tone Networks or others. Further details are available from any F-tone Networks sales representative.








