FTCT-C12-02A 1000BASE-T 电口 SFP 光模块(RJ45,100m)

产品特点 / Product Features

  • Up to 1.25Gb/s bi-directional data links
  • Hot-pluggable SFP footprint
  • Extended case temperature range
  • Fully metallic enclosure for low EMI
  • Low power dissipation
  • Compact RJ-45 connector assembly
  • Access to physical layer IC via 2-wire serial bus
  • 1000 BASE-T operation in host systems with SERDES interface
  • 10/100/1000Mbps compliant in host systems with SGMII interface

应用场景 / Applications

  • 1.25 Gigabit Ethernet over Cat 5 cable

产品概述 / Description

FTCT-C12-02A 是北亿纤通(F-tone Networks)1000BASE-T 电口 SFP 光模块,采用紧凑型 RJ-45 连接器组件与全金属屏蔽外壳,在 5 类非屏蔽双绞线上实现 1000Mbps 全双工传输,最远 100m。模块符合 IEEE 802.3-2002 与 IEEE 802.3ab,采用 5 电平脉冲幅度调制(PAM),四对线同时工作;串行 ID 信息符合 SFP MSA,可通过 2 线串行总线访问 A0h 地址,工作温度 -40~+85℃。

FTCS-C12-02ACopper Small Form Pluggable (SFP) transceivers are high performance, cost effective module compliant with the Gigabit Ethernet and 1000BASE-T standards as specified in IEEE 802. 3-2002 and IEEE 802.3ab, which supporting 1000Mbps data- rate up to 100 meters reach over unshielded twisted-pair category 5 cables. The module supports1000 Mbps full duplex data-links with 5-level Pulse Amplitude Modulation (PAM) signals. All four pairs in the cable are used with symbol rate at 250Mbps on each pair. The module provides standard serial ID information compliant with SFP MSA, which can be accessed with address of A0h via the 2wire serial EEPROM protocol. The physical IC can also be accessed via 2wire serial bus at address A0h.

技术参数 / Specifications

引脚定义 / Pin Descriptions

引脚定义 / Pin Descriptions

Pin Signal Name Description Plug Seq. Notes
1 VEET Transmitter Ground 1
2 TX FAULT Transmitter Fault Indication 3 Not supported
3 TX DISABLE Transmitter Disable 3
4 SDA SDA Serial Data Signal 3
5 SCL SCL Serial Clock Signal 3
6 MOD_ABS Module Absent. Grounded within the module 3
7 RS0 Not Connected 3
8 LOS Loss of Signal 3 Not supported
9 VEER Receiver ground 1
10 VEER Receiver ground 1
11 VEER Receiver ground 1
12 RD- Inv. Received Data Out 3
13 RD+ Received Data Out 3
14 VEER Receiver ground 1
15 VCCR Receiver Power Supply 2
16 VCCT Transmitter Power Supply 2
17 VEET Transmitter Ground 1
18 TD+ Transmit Data In 3
19 TD- Inv. Transmit Data In 3
20 VEET Transmitter Ground 1

+3.3V 电源接口 / +3.3V Volt Electrical Power Interface

The FTCS-C12-02A has an input voltage range of +3.3V +/- 5%. The 3.3V maximum voltage is not allowed for continuous operation.

Table 1. +3.3V Volt electrical power interface

+3.3V volt Electrical Power Interface
Parameter Symbol Min Typ Max Units Notes/Conditions
Supply Current Is 320 375 mA 1.2W max power over full range of voltage and temperature.
See caution note below
Input Voltage Vcc 3.13 3.3 3.47 V Referenced to GND
Maximum Voltage Vmax 4 V
Surge Current Isurge 30 mA Hot plug above steady state current. See caution note below

Caution: Power consumption and surge current are higher than the specified values in the GBIC MSA

低速信号 / Low-Speed Signals

MOD_DEF(1) (SCL) and MOD_DEF(2) (SDA), are open drain CMOS signals (see section VII, “Serial Communication Protocol”). Both MOD_DEF(1) and MOD_DEF(2) must be pulled up to Host_Vcc.

Table 2. Low-speed signals, electronic characteristics

Low-Speed Signals, Electronic Characteristics
Parameter Symbol Min Max Units Notes/Conditions
GBIC Output LOW VOL 0 0.5 V 4.7k to 10k pull-up to host_Vcc, measured at host side of connector
GBIC Output HIGH VOH host_Vcc – 0.5 host_Vcc + 0.3 V 4.7k to 10k pull-up to host_Vcc, measured at host side of connector
GBIC Input LOW VIL 0 0.8 V 4.7k to 10k pull-up to Vcc, measured at GBIC side of connector
GBIC Input HIGH VIH 2 Vcc + 0.3 V 4.7k to 10k pull-up to Vcc, measured at GBIC side of connector

高速电接口 / High-Speed Electrical Interface

All high-speed signals are AC-coupled internally.

Table 3. High-speed electrical interface, transmission line-GBIC

High-Speed Electrical Interface Transmission Line-GBIC
Parameter Symbol Min Typ Max Units Notes/Conditions
Line Frequency fL 125 MHz 5-level encoding, per IEEE 802.3
Tx Output Impedance Zout,TX 100 Ohm Differential, for all Frequencies between 1MHz and 125MHz
Rx Input Impedance Zin,RX 100 Ohm Differential, for all Frequencies between 1MHz and 125MHz

高速电接口(主机-GBIC)/ High-Speed Electrical Interface, Host-GBIC

Table 4. High-speed electrical interface, host-GBIC

High-Speed Electrical Interface, Host-GBIC
Parameter Symbol Min Typ Max Units Notes/Conditions
Single ended data input swing Vinsing 250 1200 mV Single ended
Single ended data output swing Voutsing 350 800 mV Single ended
Rise/Fall Time Tr,Tf 175 psec 20%-80%
Tx Input Impedance Zin 50 Ohm Single ended
Rx Output Impedance Zout 50 Ohm Single ended

通用规格 / General Specifications

Table 5. General specifications

General
Parameter Symbol Min Typ Max Units Notes/Conditions
Data Rate BR 10 1,000 Mb/sec IEEE 802.3 compatible.
See Notes 2 through 4 below
Cable Length L 100 m Category 5 UTP. BER <10-12

Notes:

1. Clock tolerance is +/- 50 ppm

2. By default, the module is a full duplex device in preferred master mode

3. Automatic crossover detection is enabled. External crossover cable is not required

4. 1000 BASE-T operation requires the host system to have an SGMII interface with no clocks, and the module PHY to be configured per Application Note AN-2036. With a SERDES that does not support SGMII, the module will operate at 1000BASE-T only.

环境规格 / Environmental Specifications

Table 6. Environmental specifications

Environmental Specifications
Parameter Symbol Min Typ Max Units Notes/Conditions
Operating Temperature Top 0 70 °C Case temperature
-40 85 Case temperature
Storage Temperature Tsto -40 85 °C Ambient temperature

机械规格 / Mechanical Specifications

机械尺寸 / Mechanical Dimensions

订购信息 / Ordering Information

Part Number MAC Interface Tx_DIS/
PHY Reset
1000BASE-X Auto-negotiation enabled by default Link Indicator on Rx_LOS Pin Temp.
FTCT-C12-02A SERDES/SGMII Yes Yes no -40~85°C
FTCT-C12-02A SERDES/SGMII Yes Yes Yes -40~85°C

Important Notice

Performance figures, data and any illustrative material provided in this data sheet are typical and must be specifically confirmed in writing by F-tone Networks before they become applicable to any particular order or contract. In accordance with the F-tone Networks policy of continuous improvement specifications may change without notice.

The publication of information in this data sheet does not imply freedom from patent or other protective rights of F-tone Networks or others. Further details are available from any F-tone Networks sales representative.

公司名:北亿纤通 | F-tone Networks
地区:中国四川天府新区
服务区域:全球
联系方式:
企业电话:028-85255257 | 企业传真:028-85977702 | 企业手机:19081343401
Site:https://www.f-tone.com
人事部:hr@f-tone.com | 市场部:sales@f-tone.com | 技术支持:support@f-tone.com

本产品为光模块产品线,详细信息,请联系我们的销售人员,谢谢!

Important Notice
Performance figures, data and any illustrative material provided in this data sheet are typical and must be specifically confirmed in writing by F-tone Networks before they become applicable to any particular order or contract. In accordance with the F-tone Networks policy of continuous improvement specifications may change without notice. The publication of information in this data sheet does not imply freedom from patent or other protective rights of F-tone Networks or others. Further details are available from any F-tone Networks sales representative.